Forum Replies Created
-
Posts
-
Hey gonnadobadthings, Email me at lawman5297@gmail.com and we can discuss.
I received my solenoid operated 120VAC power block yesterday. It works like a champ with the Centipede relay pod with one caveat, it is polarity sensitive. The relay pods are configure so that the tip is neg and the sleeve is pos. This is a bit contrary to normal thinking but Robert explained to me why this is. If you use one of these or any other type of relay device just remember that you may need to switch your leads at the device. Most mechanical (magnetic coil type) solenoids it doesnt really matter but solid state and digital operated ones it will.
I used this to have the Centipede turn on my vacuum pump for my SeriousKit milker and it did so just fine, no issues with heat, draw and so on.Found this on amazon. A few more bucks but Prime elgible.
I have deployed the ver 1.08 image to a 64GB Ultra disk without issue. A word of advice though. Remove and reset your card before use or remove it after use (I know, they can be lost easily). I trashed one 64GB card already, I dont think it was properly seated before I powered the Centipede up. Be sure to have another ready to go just in case.
The term “resolution” is a carry over from when I used to do some quality control work. It refers to the increments of measurements a measuring device can measure; tenths of an inch, hundredths, thousandths and so on. The smaller the increments the more precise the measurements so it has a greater “resolution.” A better term here might be “granular.” Anyway what I was referring to was to be able to more precisely control the speed so instead of adjustments being whole numbers you could make changes in tenths so 1,1.1,1.2 and so on.
I am also not really fond of the “Apply” function for the level control in the basic and stroke modes. I understand why you did it but you get a good little jolt when you raise it and hit apply. I would like to have that slider live all the time so it can be adjusted as needed. Perhaps a back door way to turn it off?I had an amazing time with this Sat. Some folks do this to porn. I feel if you have to do that then you are bored and need to try something different. I close my eyes and focus on the amazing sensations going on between my legs. Dont need any porn, the head trip of being jacked off by a computer is enough for this old computer nerd scifi junkie
For those wanting to use 3.5mm (1/8) plugs here is a link for some decent quality ones. Do not get the Uxcell brand, they fall apart.
